ANICLEAN PLUS

Developed for the preventive cleaning of the anilox cylinder, without the need to disassemble it off – press.

Excellent for water based inks and varnishes, due to its high cleaning power. ANICLEAN PLUS has a very stable formulation, carefully developed for the highly demanding print shops where production downtime needs to be optimized.

  • High cleaning capacity of the anilox assembled on the press.
  • It prevents premature cells plugging appearance.
  • Non aggressive formulation. It does not attack ceramic or steel anilox. Not for use with aluminium anilox
  • The product is water miscible according to the ink version it needs to clean and/or the printers own criteria.
  • Adequate for use with hard waters
  • Low foam appearance. Safe for use with all the press components.
ANILOX

Recommended

PARTS

Recommended

CLICHÉS

Recommended

INKING SET

Recommended

MANUAL CLEANING

Recommended

AUTOMATIC CLEANING

Recommended

UV INK

No

WB INK

Yes

SB INK

No

DILUTION

Up 1:20/ Pure

PACKAGING

Yes

Instructions for use

Maintenance cleaning: It is conducted with the anilox assembled on the press. When it is done on a weekly basis, the anilox cells premature obstruction can be avoided. Warning: Photopolymers can not be exposed to this cleaning product.

Manually: Apply generously Aniclean Plus all along the anilox cylinder and extend it uniformly while turning the anilox, than leave it to act from 10 minutes up to 2 hours according to the cleaning needs. After, rinse it off with plenty water via the press ink circulation system.

Automatically: Empty-out the ink circulation system, replace the ink with Aniclean Plus and recirculate it with the press in motion, than leave it to act from 10 minutes up to 2 hours according to the cleaning needs. After, rinse it off with plenty water via the same ink circulation system.

Deep cleaning for anilox already plugged: The anilox cylinder needs to be taken-out from the press and once it is off, the cleaning can be done either mechanically, in a cleaning machine, or manually.

Cleaning machine: Being used as the cleaning agent, Aniclean Plus can be heated up to 60º C and admit a dilution of up to 1+1 in water.

Manually: Apply the Aniclean Plus thoroughly over the whole anilox surface and leave it to act from 1 to 6 hours, than rinse it off with plenty water. Finally apply cold water at high pressure.

In case the anilox is not satisfactorily cleaned, repeat the cleaning process.

¿Tienes dudas sobre un producto?¿Necesitas ayuda experta?