FLEXO WASHOUT

Data sheet:
Security file: Este documento es sólo visible para los clientes. Si ya eres cliente accede al área de clientes. Si aun no eres cliente o tienes problemas para acceder ponte en contacto con nosotros.
  • In contrast to other solutions used previously etching, these products do not contain chlorinated hydrocarbons.
  • Optimum temperature of the etching solution between 25 and 35 ° C.
  • Short times etching.
  • Recommended drying time, 3 hours at 60 ° C (not to exceed 65).
  • Valid for any processing unit, as well for closed recirculation units.
  • The distillable product is easily used with conventional vacuum distillation equipment.
  • After distillation is recommended to mix with new product at least 20%.
  • The Flexo Washout has low odor.
  • When used properly, in accordance with its intended purpose, the Flexo Washout presents minimal risk to human health and the environment.
  • This product is not regulated for transport (ADR/RID, IMDG, IATA).
FLASH POINT

60 ºC

EFFICIENCY

High

ADR

No

ODOR

Very low

Available packaging

200L, 1000L

Instructions for use

It is recommended to perform preliminary etching tests:
  • Type photopolymer.
  • Process temperature.
  • Processing time.
  • Brush pressure.
The regeneration recommended for the washing solution is approx. 10 to 15 liters per square meter of surface and mm thick of the plate.

Do you have any question about the product?Do you need expert help?